Check your wiring before your ESP32 pays for it.

Tell the checker which board and parts you're using. It points out the connections that reset or fry boards, and shows you the safe way to wire them, before you plug anything in.

Get your lab pass

Free. Your lab pass gets you in when early access opens.

3D render of an SG90 micro servo

Checked: ESP32 + SG90 servo

  • ✕Servo powered from the ESP32 board. Every move dips the voltage and the ESP32 resets.
  • ✓Give the servo its own 5V supply, connect both grounds (GND), and add a 470µF capacitor across the servo power.

The mistakes it catches

The same rules from the One Rule videos, checked against your own parts list.

Servo powered from the ESP32 boardOwn 5V supply, common GND, big capacitor
Pull-up on GPIO 12 at bootMove it to a safe pin like GPIO 13
Bare relay or motor driven from a pinSwitch it with a transistor and a flyback diode
5V signal into a 3.3V pinLevel shifter or a voltage divider
Two supplies, no shared groundTie the grounds together

How it works

Three steps, no account needed for the basic check.

Pick your board and parts

ESP32, UNO, servo, relay, motor, sensors. Choose what's on your bench.

See every risky connection

Each problem is marked on the wiring, with the reason it fails.

Get the safe wiring

A corrected diagram and starter code you can copy.

Early access opens a few makers at a time.

Get your lab pass and tell us what keeps breaking on your bench.

Get your lab pass